Mori Seiki Ex Alarm List Info

Alarm: 1010 / X-axis SERVO ALARM

: Sudden drop in incoming air pressure.

Pneumatic pressure has fallen below the safe operating threshold .

: The door lock signal was not confirmed within the expected timeframe. mori seiki ex alarm list

Open your Fanuc or Mitsubishi control screen to view current I/O bit states: Press the key. Select the PMC softkey, then choose DIAGNOSIS or STATUS .

Check the electrical manual to see the "truth table" for that specific alarm.

A huge percentage of EX alarms are just the machine asking for food. Check the way lube, hydraulic oil, and coolant tanks first. 4. Clean the Sensors Alarm: 1010 / X-axis SERVO ALARM : Sudden

Alarms generated by accessories connected to the main CNC unit.

Hydraulic pressure dropped below the safe operating limit (usually required for chucking, tailstock, and tool unclamp).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Open your Fanuc or Mitsubishi control screen to

Locate the proximity switch, limit switch, or pressure sensor tied to the alarm description. Clean away stuck metal chips, wiping off oily sludge that can bridge magnetic sensors. 3. Utilize the Diagnostic Screen (NC Side)

The way lube pressure did not reach the required threshold during a lubrication cycle.