If you’d like me to help you from that manual, just paste the text or describe the diagram, and I’ll explain it clearly.
The cables should be taut but not lifting the top weight plate off the stack when the machine is at rest. If there is too much slack, adjust the pulley positions using the alternative holes in the brackets.
If the machine squeaks, lubricate the main pivot bolts on the arms. dp dual trac 20 assembly instructions full
Bolt the seat support structure to the front side of the main vertical upright.
The carriages slide on the front tracks of the uprights. If you’d like me to help you from
Take the second cable and anchor it to the low pulley bracket near the front foot stabilizer.
: Secure these bars to the bottom piece using two carriage bolts . Use a 9/16" wrench to tighten, but leave them slightly loose until the main post is mounted to allow for adjustment. If the machine squeaks, lubricate the main pivot
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.