Proteus Mc1496 Lib ^new^ Jun 2026

To configure the Mc1496:

Open Proteus Schematic Capture. Press the key on your keyboard to open the "Pick Devices" window. Type MC1496 into the keywords box. The device should appear under the analog or communication category. Setting Up an AM/DSB-SC Simulation in Proteus

Q: How do I use the Proteus Mc1496 Lib? A: The library can be downloaded and installed, and then added to a Proteus project. The user can then select the MC1496 model, configure the simulation, and run the simulation. Proteus Mc1496 Lib

Essential for adjusting the carrier balance.

: Most standard versions of Proteus already include the MC1496. You can find it by: Opening the Schematic Capture window. To configure the Mc1496: Open Proteus Schematic Capture

When to use it

Troubleshooting: If it doesn’t appear, go to and verify that your Library Path points to the folder where you placed the files. Then go to Tools > Rebuild Library Index . The device should appear under the analog or

Two independent AC voltage sources ( VSINE ) to simulate the carrier wave and the modulating signal.

If the library model is correct, you should see a DSBSC waveform – a 100 kHz carrier whose amplitude varies sinusoidally at 1 kHz, with a phase inversion at the zero crossing of the modulating signal. If you see a standard AM waveform (carrier always present), your biasing or input levels are off – a good test of the model’s accuracy.