The radio felt heavy in Miguel’s hand, not with weight, but with silence. The IC-F310 was a brick of black and grey, built for logging trucks and security guards. On the bench next to it sat a relic: a Lenovo laptop running Windows XP, its screen cracked at the corner but its heart still loyal to legacy ports.
Ensure your USB programming cable uses a high-quality, genuine chipset, such as FTDI or Silicon Labs (CP210x) . Cheap cables often use counterfeit Prolific chips, which fail to work or experience driver errors on modern Windows operating systems. 3. Step-by-Step Programming Process
After installing your USB cable driver, go to Device Manager > Ports (COM & LPT) . Right-click your USB Serial Port > Properties > Port Settings > Advanced. Change the COM Port Number to COM2 or COM3 .
The adjustment software warns: If the EEPROM (the chip storing settings) is replaced or corrupted, the radio may beep and display an error until you reload the saved .icf file backup. Never lose your original factory backup file.
This means Windows does not recognize your USB cable chipset. Download the official, up-to-date drivers directly from the FTDI or Prolific websites rather than letting Windows search for them automatically. Icom Ic-f310 Programming Software
The software (if available) runs natively on 64-bit Windows. The Icom CS-F300S may run on Windows 7 32-bit but is unstable on Windows 10/11 64-bit unless compatibility mode is enabled. The OPC-2344-1 interface is fully plug-and-play with modern Windows drivers.
Insert the RJ-45 end of the programming cable into the microphone jack. Connect the USB/Serial end to your computer.
The standard IC-F310 covers a frequency range of , while the IC-F320 covers 146–174 MHz (H-band) . Depending on the firmware and hardware revision, the radio can support up to 32 channels (organized in 16 channels across 2 banks), making it suitable for complex fleet communications.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. The radio felt heavy in Miguel’s hand, not
Assign alphanumeric names to your channels if your specific display model supports it. Step 5: Writing to the Radio
Select (or press the dedicated Read icon) to pull the current configuration file from the radio.
Icom IC-F310 is an older analog VHF mobile transceiver that requires specific legacy software and hardware for configuration. To program this radio, you primarily need the Icom CS-F300 and a compatible cloning cable. Programming Software Details Official Software: Icom CS-F300 for "S" model variants).
It is always best practice to "Read" the radio before writing new data. Ensure your USB programming cable uses a high-quality,
: The original software often requires MS-DOS or older versions of Windows (like XP) to run correctly. If you are using a modern PC, you may need a DOS emulator or a dedicated legacy machine. Required Hardware & Cables
is usually needed to connect the OPC-478 cable to the radio's modular jack. Alternative:
This indicates data corruption during transfer. It is usually caused by using a cheap USB cable chipset, bad emulation settings in DOSBox, or RF interference. Keep the radio away from other transmitting devices while cloning.