Loader For Iphone9 3-d101ap Not Found [patched] -

In short, if you are using official Apple software, you will never see this error. Its presence means you are operating – likely in a DFU or PWNDFU state.

“idevicerestore -e gives loader error.” Solution: The user compiled idevicerestore from source without the --with-loader-path flag. After recompiling with ./configure --prefix=/usr --with-loader-path=/usr/share/idevicerestore , the loader was found. Lesson: Compilation flags matter.

Failing NAND flash memory (the internal storage) preventing the phone from reading system files. How to Fix "Loader For Iphone9 3-d101ap Not Found"

If Recovery Mode fails, a DFU restore bypasses the corrupted bootloader entirely to flash the storage chip from scratch. Plug your iPhone into your computer and open iTunes/Finder. Hold the and Volume Down buttons for 8 seconds. Loader For Iphone9 3-d101ap Not Found

If the basic troubleshooting steps fail, consider these more advanced approaches:

For users experiencing this issue while utilizing open-source jailbreak utilities or manual components like idevicerestore , the tool may look for the device manifests in the wrong directory.

The tool you are using was compiled before the d101ap board was recognized. Many open-source restores haven’t been updated since 2018. They contain loaders for n71ap (iPhone 6s) or d10ap (iPhone 7 global), but d101ap (the variant Intel modem board). Fix: Update the tool or manually add the missing loader. In short, if you are using official Apple

This requires deep understanding of ARM64, Apple’s SecureROM, and the A10 exception vectors. Do not attempt on your daily driver.

The throwing this error (e.g., iTunes, 3uTools, Checkra1n)

Corrupted USB drivers prevent loaders from executing properly. Disconnect your iPhone from the computer. After recompiling with

Using incompatible or outdated tethered jailbreak tools (like checkra1n or palera1n) that push the wrong bootloader to the device.

Do not use outdated software. For iPhone 8 (d101ap), the only modern tools that properly support it are:

If the tool tries to automatically force your device into DFU (Device Firmware Update) mode, it might read the device ID incorrectly. Disconnect your iPhone 7 from the PC.

If your tool allows manual board selection (e.g., ipwnder or gaster ), force it to use d101ap :

“I’m trying to jailbreak my iPhone 7 (iOS 14.8) with checkra1n on Ubuntu 20.04. Error: Loader for iPhone9 3-d101ap not found.” Solution: The user had an older checkra1n binary (v0.12.2). After updating to checkra1n 0.12.4 (which added support for Intel-based iPhone 7 boards), the error disappeared. Lesson: Always use the latest beta.