The error should disappear. You have effectively used the free download and installation (extraction) of the Canon Service Tool ST 5510.
Because the Service Tool is an internal utility, Canon does not host it on public consumer support pages. To download it safely:
The printer will print a small line ("D=000.0") to confirm the reset.
To safely proceed:
Have you successfully used the ST-5510? Share your experience in the comments below (but please don't share direct download links – keep the community safe).
Keep holding the Power button, then .
To use the ST V5510, you must first put your Canon printer into Service Mode: the printer (keep it plugged in). Press and hold the Stop/Reset button. While holding Stop/Reset, press and hold the Power button. Release the Stop/Reset button (while still holding Power).
Turn off your printer using its physical power button (it may take a few seconds to shut down completely), then turn it back on normally. Your printer is successfully reset. Troubleshooting Common Error Codes Error Code Printer not in Service Mode
The Canon Service Tool V5510 is an official proprietary software used by Canon technicians to diagnose, maintain, and reset Canon Pixma G, MG, MP, and IP series printers. Key Features
If you still wish to proceed with a downloaded version, follow this guide to protect your computer and printer.
The is an official software program used by technicians to perform maintenance on Canon Pixma and Maxify series printers. It is primarily sought after for resetting the internal waste ink absorber counter when a printer halts operations with the dreaded "Ink Absorber Full" error (such as error codes 5B00, 1700, or 1701). 🛠️ Key Features of Canon Service Tool ST V5510
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The printer is not actually in Service Mode. Turn it off and try the button sequence again. Conclusion
Explain how to after resetting the software. Let me know which you need! Share public link
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
In the section, ensure "Main" is selected in the dropdown.
Resetting the counter without addressing the physical waste ink pad will eventually lead to ink leaking inside your printer. After using ST 5510:
