Datasheet — Mx1616 Motor Driver

The (often referred to simply as MX1616) is a dual-channel H-bridge brushed DC motor driver designed for low-voltage, high-current applications such as toy motors and small robotics. It is frequently marketed as a more efficient, compact alternative to the classic L298N driver, utilizing MOS technology to reduce heat and voltage drop. Technical Specifications Overview

Always double-check the specific datasheet provided by your module's supplier, as clone variations of the MX1616 chip may have slight differences in peak voltage tolerance.

Battery Negative ➡️ MX1616 and Arduino GND (Common Ground) Arduino Sample Code

When both inputs are HIGH, both outputs are driven LOW, creating a dynamic braking condition. Avoid simultaneous high-current braking for >5 seconds without heatsinking. Mx1616 Motor Driver Datasheet

Speed control is achieved by applying a Pulse Width Modulation (PWM) signal to the driving pin while keeping the other pin LOW. This unique "direct drive" architecture is a key advantage over drivers requiring a separate enable pin, as it allows for more advanced control techniques with fewer I/O pins.

to test the directional control and PWM speed of this driver? H-Bridge DC Motor Driver Module MX1616

The truth table for a single H-bridge channel (IN1, IN2 for Motor A) is: The (often referred to simply as MX1616) is

Most MX1616 modules follow a standard 8-pin or SOP16 interface for control and power: + (VM/VCC): External motor power supply (2V–10V). - (GND): Common ground for both power and logic signals. Control Inputs: IN1 / IN2: Controls Motor A direction and speed (PWM). IN3 / IN4: Controls Motor B direction and speed (PWM). Motor Outputs:

Ultimate Guide to the MX1616 Motor Driver Datasheet The MX1616 is a highly efficient, dual-channel H-bridge motor driver integrated circuit (IC). It is widely used in robotics, smart toys, and battery-powered electronics. This comprehensive guide breaks down its technical specifications, pin configuration, and practical applications. 📌 Technical Overview and Key Features

The MX1616H is a dual-channel, MOSFET-based H-bridge DC motor driver IC designed for low-voltage, small-scale robotics applications, operating between 2V and 8.6V. It provides a continuous output current of 1.3A to 1.6A per channel, features internal thermal protection, and acts as an efficient alternative to older drivers like the L298N. For complete technical details, consult the Sinotech Mixic Electronics datasheet . MX1616H - Mikrocontroller.net Battery Negative ➡️ MX1616 and Arduino GND (Common

Stresses beyond these values may cause permanent damage.

Ensure the motor power supply matches the 2V–8.6V range. Using higher voltages (like a 12V lead-acid battery) will damage the chip.

This article provides an in-depth analysis of the , focusing on technical specifications, pin configuration, application circuits, and integration with microcontrollers like Arduino. 1. What is the MX1616?